Table of Contents
Advertisement
Figure 120 Pushing the drive drawer into the system enclosure
6.
Replace the enclosure as described in
Removing and replacing the rack rails
For detailed instructions on installing the rack rails, see the HP 3U Storage System Rail Kit Installation
Instructions.
Removing and replacing server blades
Removing the server blade
CAUTION:
support the weight of the server blade by handling the chassis directly. Improper use can damage
the release lever and the server blade.
1.
Verify the failed component as described in
2.
Power off the appropriate server blade by clicking Start and then select Shut Down.
3.
Remove the server blade
a.
Push the button to release the handle (1).
b.
Pull the handle toward you (2).
c.
Remove the server blade (3).
Figure 121 Removing the server blade
108 Removing and replacing hardware components
Do not use the server blade release lever to lift or carry the server blade. Always
(Figure 121 (page
"Inserting the system enclosure into the rack" (page
"Verifying component failure" (page
108)):
68).
66).
Advertisement
Table of Contents
