Table of Contents
Advertisement
Figure 97 Pushing the drive drawer into the system enclosure
7.
Replace the top back panel.
8.
Replace the drive fan module.
9.
Replace both SAS I/O modules.
10. Replace the enclosure as described in
Removing and replacing the drive drawer hard drive
CAUTION:
Do not replace the hard drive with a SATA drive. Be sure to replace the hard drive only with
an approved SAS drive.
Do not replace the drive drawer hard drive during peak data transfer times. Make sure the
hard drive LED is off before you remove the hard drive.
Ensure that the capacity of the replacement drive is at least equal to the capacity of the original
drive. The capacity of the replacement drive should not be smaller.
NOTE:
After replacing the hard drives, the approximate wait times for viewable disk LED activity
vary.
Removing the drive drawer hard drive
1.
Verify the failed component as described in
96
Removing and replacing hardware components
"Inserting the system enclosure into the rack" (page
"Verifying component failure" (page
68).
66).
Advertisement
Table of Contents
