Table of Contents
Advertisement
4.
Complete the following
a.
Disconnect the LED display board from the drive backplane by pinching the ends of the
LED display board cable together (1).
b.
Remove the four screws from the LED display board (2).
c.
Remove the LED display board from the drive drawer (3).
Figure 82 Removing the front LED display board
Replacing the front LED display board in the rack
1.
Complete the following
a.
Install the replacement LED display board (1).
b.
Replace the four LED display board screws (2).
c.
Reconnect the LED display board to the drive drawer (3).
Figure 83 Installing the front LED display board
2.
Replace the front bezel as described in
Removing and replacing the front LED display board (full)
Removing the front LED display board (full)
1.
Verify the failed component as described in
2.
Power off the system as described in
3.
Remove the enclosure as described in
(Figure 82 (page
89)):
(Figure 83 (page
89)):
"Replacing the front bezel" (page
"Verifying component failure" (page
"Powering the storage system off and on" (page
"Removing the system enclosure from the rack" (page
Removing and replacing the front LED display board (full)
86).
66).
60).
67).
89
Advertisement
Table of Contents
