Mounting Brackets, Slide Rails, And Bar Nuts - HP StorageWorks HA-Fabric Manager Installation Manual
Manager appliance
Hide thumbs
Also See for StorageWorks HA-Fabric Manager:
- Release note (10 pages) ,
- Installation manual (82 pages)
Table of Contents
Advertisement
Figure 1.3. Mounting Brackets, Slide Rails, and Bar Nuts
•
Mounting screws:
•
Ten (10) pan-head Phillips screws (#10 x 1/2) with split lock and flat washers that
secure the bracket assemblies to the vertical rack-mounting standards.
•
Ten (10) pan-head Phillips screws (M4 x 10 centimeter) with split lock and flat washers
that secure the slide rails to the appliance.
•
Four (4) flat-head Phillips machine screws (#8 x 7/16) that secure the two-hole bar
nuts, front brackets, and rear brackets.
•
Two (2) hexagonal-nut standoffs.
Figure 1-4
20
illustrates the standoff and mounting screws.
hp StorageWorks HA-Fabric Manager Appliance Installation
Chapter 1. Initial Setup
Guide
Advertisement
Table of Contents
