Millivolt Board Installation - kozy heat Thief River Falls-TRF 56701 Installation And Operation Manual

WARNING: DO NOT OPERATE THIS FIREPLACE WITHOUT SEALING
GASKET (LOCATED UNDER THE MILLIVOLT BOARD) IN PLACE. IF
GASKETING IS DAMAGED, IT MUST BE REPLACED.
1. Place millivolt board in firebox, aligning the holes in the
millivolt board with holes in the firebox bottom. MAKE
SURE SEALING GASKET IS IN PLACE ON FIREBOX
BOTTOM! Secure millivolt board to firebox bottom with
the (6) screws previously removed.
2. Install log grate / burner heat shield assembly into fireplace,
making sure entire assembly (front flange) is inside firebox
when completed.
3. Reinstall front log supports, securing with screws previously
removed.
4. Reinstall burner tube, sliding venturi over millivolt board
orifice, placing mounting holes in burner tube over tabs on
log grate / burner heat shield assembly.
5. LP Gas Models: Reinstall LP log plate.
6. Reinstall pilot shield.
7. Reinstall refractory panels (if applicable).
8. Reinstall bottom refractory panels.
9. Reinstall log set. (Pages 32-34).
10. Reconnect gas line to manual shut-off valve.
11. Model 5670: Reconnect any wall switch, remote control or
thermostat wires to the top & bottom terminals on the gas
valve.
Model 56701-RF: Re-connect the (2) wires to fan cord. Plug
fan cord into receptacle.
12. Reinstall glass frame assembly. Page 14.
13. Reinstall upper louver, upper hood and lower grill. Page 37.
14. Turn gas on.
15. Verify proper log placement, operation of fireplace, and any
electrical components.
CAUTION: CHECK ALL CONNECTIONS FOR LEAKS,
WHETHER FIELD OR FACTORY MADE.

MILLIVOLT BOARD INSTALLATION

LOG GRATE / BURNER HEAT SHIELD
BURNER TUBE
RE-CONNECT ANY REMOTE /
THERMOSTAT WIRES
PAGE 36
NOTE: Illustrations shown with
56701 valve components.
FRONT LOG SUPPORTS
PILOT SHIELD