Millivolt Board Installation - kozy heat 932 Direct Vent Installation And Operating Manual

INSTALLING THE BOARD.
NOTE: This fireplace is fitted with a gasket to seal the millivolt board to the firebox. Make certain this gasket is prop-
erly placed around the opening before installing the millivolt board.
1. Place the board into the firebox, aligning the (8) 1/4" holes in the board to the (8) mounting studs on the firebox
bottom.
CAUTION: Before securing the board into place make sure that all of the wires (attached under the board)
are clear and unobstructed.
PILOT SHIELD
2. Attach the 1/4" nuts (included with the board assembly) and tighten.
3. Replace the burner cover assembly, properly seating the burner tube over the orifice. The burner cover should
be ‟inside‟ the flanges on the board. Adjust burner venturi setting. Follow instructions included in the fireplace
components packet. For Natural Gas, this setting should be 3/16". For LP, this setting should be 3/8".
IMPORTANT: Ensure that the burner tube is properly seated over the burner orifice.
Page 18