Millivolt Board Removal / Installation - kozy heat 936 Installation & Operating Manual

NOTE: The unit is equipped with the millivolt board already installed. Follow these
procedures should the millivolt board need replacing or is removed for servicing.
MILLIVOLT BOARD REMOVAL.
1. Shut off the gas supply at the manual
shut-off valve.
2. Disconnect gas line flex tube from the
manual shut-off valve.
3. Disconnect any wall switch, remote
control or thermostat from the valve.
Figure 10A
6. Loosen and remove the (8) 1/4" nuts and, while grasping the board, gently lift it off the (8) bolts
and remove from the unit.
Figure 10B
4. Remove the logs from the unit.
5. Loosen and remove the (2) 1/4" nuts
securing the burner tube & burner cover
assembly and remove.
Page 15