Prepare The Fireplace; Nailing Flange Assembly & Installation; Top Stand-Off Adjustment - kozy heat Thief River Falls-TRF 56701 Installation And Operation Manual

NAILING FLANGE ASSEMBLY & INSTALLATION
When installed, nailing flanges provide the minimum 1/4" (6 mm) clearance from fireplace sides.
1. Remove the (4) nailing flanges from fireplace sides.
2. With the 1/4" (6 mm) stand-offs on the nailing flanges facing away from fireplace, align nailing flange with the holes on the outside
corners of fireplace . Secure with screws (provided in installation manual parts packet) through the slots in the nailing flanges .
3. Bend perforation on nailing flange until parallel with fireplace face. Do not bend toward fireplace face.
4. Position framing stud against the 1/4" (6 mm) stand-off located on the backside of the nailing flange and secure with nails or screws.
NOTE: Depending on facing material, nailing flanges can be
adjusted forward or back up to 1/2" (13 mm).
NAILING FLANGES
INSTALLED
AS SHIPPED

TOP STAND-OFF ADJUSTMENT

The top stand-off is adjustable to accommodate finish material thickness
(non-combustible material only).
TO ADJUST: Loosen screws at fireplace top, slide top stand-off to desired
position, retighten screws.

PREPARE THE FIREPLACE

1/4" (6mm)
CLEARANCE
NAILING FLANGE
FRAMING STUD
FRONT VIEW
CAUTION: NEVER PERMANENTLY REMOVE THESE ASSEMBLIES
FROM THE FIREPLACE - THEY MUST BE SECURED IN PLACE
REGARDLESS OF FINISH MATERIAL USED.
1/4" (6mm)
CLEARANCE
TOP VIEW
TOP STAND-OFF ADJUSTMENT SLOTS
PAGE 9
STAND-OFF
FRAMING STUD
NAILING FLANGE