kozy heat Thief River Falls-TRF 56701 Installation And Operation Manual page 17

OPTIONAL FAN INSTALLATION (56701 only)
1. Insert fans through the lower grill opening, push to the back, posi-
tioning behind legs. Align mounting slots in fan brackets onto the
mounting studs. Secure with nuts.
2. Connect fan wiring by attaching connectors on right fan onto termi-
nals on left fan.
3. From inside the lower right grill opening, loosen screw securing
removable access panel (with electrical box & romex connector
installed). Remove panel.
4. Insert 115V wiring (with ground) through romex connector and
wire to the speed control / receptacle assembly, matching the black
(hot), white (neutral), and green (ground) wires to the correspond-
ing wires on the speed control / receptacle assembly.
5. Secure speed control / receptacle assembly to the electrical box with
(2) screws provided.
NOTE: Speed control / receptacle assembly & (3) wire
nuts are included in the fireplace components packet.
6. Re-install electrical access panel. Tighten screw.
7. Attach the temperature control switch to the bottom of firebox.
8. Plug cord into the electrical box receptacle.
9. Turn speed control counter-clockwise until it „clicks‟. This is the
„OFF‟ position.
10. Turn speed control „ON‟ by turning knob clockwise past the „click‟
- this is the highest setting.
11. Re-install glass assembly.
12. Re-install lower grill, upper louver & upper hood. Refer to page 37
of this installation manual if necessary.
NOTE: This appliance must be electrically grounded
and connected in accordance with local codes, or in the
absence of local codes, with the National Electrical
Code, ANSI/NFPA 70 Current Edition, or the Cana-
dian electrical Code CSA C22.1.
NOTE: This fan will not operate unless the speed con-
trol has been turned „ON‟ and sufficient heat has been
applied to the temperature control switch. The fan will
turn „ON‟ and „OFF‟ automatically as the fireplace
heats and cools. Adjust fan to desired speed while it is
running.
Fans sit behind legs
Temperature Control Switch (Looking through lower grill opening).
TEMPERATURE CONTROL SWITCH POSITION
Before adjusting the temperature control switch, unplug the 3-prong
plug on the fan cord from the receptacle. Adjust position of the
temperature control switch to a warmer location under the firebox to
turn fan „ON‟ sooner or move it to a cooler location under firebox
to turn the fan „ON‟ later. The fan will turn on when the sensor in
the temperature control switch reaches 110° F and will turn „OFF‟
when the sensor reaches 90° F. After adjustment, plug the 3-prong
plug on fan cord into the receptacle.
PAGE 16
Connect fan wiring