Table of Contents
Advertisement
WARNING: DO NOT OPERATE THIS FIREPLACE WITHOUT SEALING
GASKET (LOCATED UNDER THE MILLIVOLT BOARD) IN PLACE. IF
GASKETING IS DAMAGED, IT MUST BE REPLACED.
1.
Place millivolt board in firebox, aligning holes in the mil-
livolt board to the mounting studs in firebox bottom. MAKE
SURE SEALING GASKET IS IN PLACE ON FIREBOX
BOTTOM! Secure millivolt board to firebox bottom with
the (6) nuts previously removed.
2.
Reinstall burner plate, aligning between tabs on millivolt
board.
3.
Reinstall burner tube by positioning over burner orifice and
aligning mounting holes at sides of burner tube over tabs on
millivolt board.
4.
Reinstall log set. (Page 23).
5.
Reconnect gas line to manual shut-off valve.
6.
Reconnect any wall switch, remote control or thermostat
wires to the top & bottom terminals on gas valve.
7.
Reinstall glass frame assembly. Page 12.
8.
Reinstall upper grill. Page 26.
9.
Turn gas on.
10. Verify proper log placement, operation of fireplace, and any
electrical components.
CAUTION: CHECK ALL CONNECTIONS FOR LEAKS,
WHETHER FIELD OR FACTORY MADE.
MILLIVOLT BOARD INSTALLATION
PILOT
BURNER TUBE
BURNER PLATE
RE-CONNECT ANY REMOTE /
THERMOSTAT WIRES
PAGE 25
CORRECT BURNER TUBE /
BURNER ORIFICE
POSITIONING
Advertisement
Table of Contents
Troubleshooting
