Log Set Installation - kozy heat 911XL Installation And Operation Manual

#936-50E LOG SET INSTALLATION
ATTENTION: If converting to LP (propane) gas, do so now before installing log set. Follow instructions included with conversion kit.
NOTE: Log numbers are located on the bottom of each log. Refer to following instructions and illustrations for proper placement.
CAUTION: Do not place logs directly over burner port holes. Improper log placement may affect flame appearance and cause excessive
soot to build up on logs and glass.
Position base logs onto burner cover in the following order: X1, X2, X3 & X4. Align mounting holes in bottom of logs to the
corresponding mounting studs. Pull X1 log forward toward burner tube.
Brush Rock wool embers onto burner and base logs with a stiff bristle brush.
Position X6, X7, & X8 logs onto alignment cut-outs on base logs.
Position top logs X9 & X10 onto alignment cut-outs on base and middle logs.
X3
X6
klinkers
X9
Place klinkers along front of burner cover directly behind log grate.
Brush additional Rockwool embers onto logs.
PAGE 24
X1
X2
X7
X8
X10
X4