kozy heat 911XL Installation And Operation Manual page 29

LIGHTING AND SHUTDOWN (cont.)
LIGHTING
1. Set thermostat to the lowest setting, if installed.
2. Turn off all electrical power to the appliance. (Fan).
3. Open lower grill to access the gas valve & controls.
A. Push gas control knob in slightly and turn
clockwise to "OFF". Wait five (5) minutes to allow any gas
that may have accumulated inside the firebox to escape. If
you then smell gas, STOP! Follow the safety information
on the front cover and on the previous page of this installa-
tion manual. If you don‟t smell gas, go to the next step.
NOTE: Gas control knob cannot be turned from "PILOT" to
"OFF" unless knob is pushed in slightly. Do not force.
B. Locate pilot - follow metal tube from gas
control. The pilot is located inside the
combustion chamber.
C. Push gas control knob on the gas valve in slightly and
turn counterclockwise to „PILOT‟. Push valve knob in
and hold while repeatedly pressing the piezo igniter
button until the pilot is lit while continuing to hold in
the gas control knob.
D. Hold gas control knob in for one (1) minute
after pilot is lit. Release the gas control knob. If the
pilot goes out, repeat steps C-D. When the pilot is lit,
proceed to step E.
CAUTION: If knob does not pop up when released, stop and
immediately call your service technician or the gas supplier.
If the pilot will not stay lit after several tries, turn the gas
control knob to OFF and call your service technician or the
gas supplier.
E. Push gas control knob in slightly and turn
counterclockwise to „ON‟. The burner can now be
turned „ON‟ by depressing the ON/OFF rocker
switch located beside the valve, or wall switch, OR
by setting the thermostat or remote control to the
desired setting.
F. Turn on all electric power to the appliance (if appli-
cable).
NOTE: When the fireplace is initially lit, condensation
will appear on the glass; this is normal in all gas
fireplaces and will disappear after several minutes.
A
B
C
D
PAGE 27
5 MINUTES
PILOT
PILOT TUBE
1 MINUTE
E