Zc Shroud Assembly And Installation - kozy heat 911XL Installation And Operation Manual

ZC SHROUD ASSEMBLY AND INSTALLATION

Shroud assembly includes:
IMPORTANT: You will need the following items from the insert components packet:
Rocker switch wires
1. Remove nuts from upper grill. Place grill rods through holes in shroud top section. Secure with nuts. If necessary, recess upper
grill by re-positioning in one of three mounting holes.
2. Secure right and left shroud sections to top section by aligning (2) holes in side sections to holes in top section. Secure with phillips
head screws (2 ea. side).
OPTIONAL: Attach shroud extensions by aligning slots in shroud with desired
hole in shroud extension. Secure with phillips head screws.
3. Snap rocker switch into place on shroud.
4. Slide one connector on each rocker switch wire to the rocker switch.
5. Attach shroud to insert by placing tabs on left and right shroud pieces into slots in insert. The shroud will set into place.
6. Slide remaining connectors on rocker switch wires to terminals on gas valve marked „TH‟ and „THTP‟.
7. Remove nuts from lower grill, insert grill bolts through lower hinges on insert. Attach and tighten nuts.
IMPORTANT: CHECK ALL CONNECTIONS WHETHER FIELD OR FACTORY MADE, FOR LEAKS.
(1) Shroud top
(1) Shroud left side
(1) Shroud right side with on/off rocker switch mounting hole
You will also need the grill set (sold separately) .
(8) Phillips head screws
(2) Shroud extensions
On/Off Rocker switch
PAGE 21