kozy heat 911XL Installation And Operation Manual page 25

MASONRY SHROUD ASSEMBLY AND INSTALLATION
IMPORTANT- MOUNTING BRACKET ORIENTATION
The right mounting bracket is notched out at the bottom. Figure 1.
Flanges on both mounting brackets face the inside of insert. Figure 1.
1. Align holes in mounting brackets to the corresponding holes in insert face, making
sure brackets are positioned as shown in Figure 1. Secure with screws provided
(Figure 2).
2. Position tabs (lower end previously removed) on shroud into slots in the insert face,
aligning oblong holes on inside flange of shroud side sections to holes in mounting
brackets. Secure with (4) screws (C), 2 each side. Figure 3.
3. Slide remaining connectors on rocker switch wires to terminals on gas valve marked
„TH‟ / THTP‟.
4. Remove nuts from lower grill, insert grill bolts through lower hinges on insert.
Attach and tighten nuts. Figure 4.
OPTIONAL MASONRY PANEL INSTALLATIONS:
1. Remove screws (A) (2 ea. side) securing the masonry panels. Figure 2.
2. Align holes in mounting brackets to the corresponding holes in insert face & ma-
sonry panels, making sure brackets are positioned as shown in Figure 2. Secure
with screws removed in step1and included in shroud components packet.
3. Position tabs (lower end previously removed) on shroud into slots in the insert
face, aligning oblong holes on inside flange of shroud side sections to holes in
mounting brackets. Secure with (4) screws (C), 2 each side. Figure 3.
4. Slide remaining connectors on rocker switch wires to terminals on gas valve
marked „TH‟ / „THTP‟.
5. Remove nuts from lower grill, insert grill bolts through lower hinges on insert.
Attach and tighten nuts. Figure 4.
Secure shroud to brackets
at inside flange
Figure 3
C
IMPORTANT: CHECK ALL CONNECTIONS WHETHER FIELD OR FACTORY MADE, FOR LEAKS.
Secure brackets at top & bottom
holes with screws provided.
Figure 2
PAGE 23
Note flange orientation
Figure 1
A
Figure 4
B