Masonry Shroud Assembly And Installation - kozy heat 911XL Installation And Operation Manual

MASONRY SHROUD ASSEMBLY AND INSTALLATION

Shroud assembly includes:
IMPORTANT: You will need the following items from the insert components packet:
1. Remove nuts from upper grill. Place grill rods through holes in shroud top section. Secure with nuts.
2. Secure right and left shroud sections to top section by aligning holes in side sections to holes in top section. Secure from bot-
tom with screws provided (2 ea. side).
3. Snap rocker switch into place on shroud. Slide one connector on each rocker switch wire to the rocker switch.
Screws are secured from the bottom.
ATTACH THE SHROUD
OUTSIDE FIT APPLICATIONS:
1. Attach shroud to insert by inserting tabs (A) on left and right shroud sections to holes (B) in insert face. The shroud will set down
into place.
2. Slide remaining connectors on rocker switch wires to top and bottom terminals marked „TH‟ and „THTP‟ on the gas valve.
3. Remove nuts from lower grill, insert grill bolts through lower hinges on insert. Attach and tighten nuts.
INSIDE FIT APPLICATIONS: ( You will require the „inside fit‟ brackets included with shroud assembly).
1. Remove glass frame assembly. Refer to page 9 if necessary.
2. Referring to illustration at right, use a tin snips to remove lower
end of (4) mounting tabs on shroud side sections.
(1) Shroud top
(1) Shroud left side
(1) Shroud right side with on/off rocker switch mounting hole
Rocker switch wires
You will also need the upper grill from the grill set (sold separately) .
(8) Phillips head screws
(1) Set „inside fit‟ brackets
On/Off Rocker switch
Remove lower end of each tab (4)
PAGE 22
Snap On/Off rocker switch into
mounting hole as shown.