Components List; Additional Components Required; Placement Clearance Requirements - kozy heat 911XL Installation And Operation Manual

MODEL #911XL COMPONENTS LIST
(#9XL-770) - Millivolt Board Assembly with 18" Flexible Gas
Line attached
(#700-203) - Manual Gas Shut-off Valve
(#9XL-135) - Burner Assembly
(#9XL-G900) - Refractory Set
(#936-50E) - Log Package
(#700-07T) - Glass with Gasket
(#9XL-005) - Glass Valance
(#OCK-S50A) - LP Conversion Kit
(#815-CL2) - Co-Linear Air Chute
(#XXL-028) - Fan Kit (2)-75 CFM
(#900-085) - 4" Restrictor Plate

ADDITIONAL COMPONENTS REQUIRED

Vent System; Part #815-CL: For use with minimum 6" x 8" I.D. masonry or 8" I.D. Class A metal chimneys - Includes 12 ft. (3.66 m)
Part #510: Used in conjunction with #815-CL to extend termination up to a maximum of 40 ft. (12.19 m).
Other approved venting: Selkirk, ICC, American Metals, Security
Shrouds - 3 pc & 4 pc.: Standard shrouds are available for this insert and will fit most applications. Custom shrouds may be ordered on a
non-returnable basis. When ordering a custom shroud, please specify the existing fireplace front opening height
and width. Grill set (required) in various finishes purchased separately.
Blank Shrouds - 3 & 4 pc.: Blank shrouds are available for on-site custom fit applications and are sized to the opening after the insert has
been installed. The interior perimeter is properly sized to fit onto the insert. The outer perimeter must be cut,
formed and finished (painted). Grill set (required) in various finishes purchased separately.
Full Door Shrouds: Full door decorative shrouds are available for this insert and are used in place of a standard or blank shroud.

PLACEMENT CLEARANCE REQUIREMENTS

This fireplace must be installed on a level surface capable of supporting the fireplace and venting.
This fireplace insert is to be installed into a solid fuel masonry or factory built non-combustible fireplace that has been installed in
accordance with the National, Provincial, State and local building codes.
Due to high surface temperatures, fireplace should be located out of traffic and away from furniture and draperies.
This fireplace may be installed in a bedroom.
Please be aware of the large amount of heat this fireplace will produce when determining a location.
SPECIFICATIONS
compressed, expandable to 25 ft (7.62 m) co-linear 3" x 4" flexible chimney, and termination cap.
MODEL #911XL-RAD COMPONENTS LIST
(#9XL-770) - Millivolt Board Assembly with 18" Flexible Gas
Line attached
(#700-203) - Manual Gas Shut-off Valve
(#9XL-135) - Burner Assembly
(#9XL-G900) - Refractory Set
(#936-50E) - Log Package
(#700-07T) - Glass with Gasket
(#9XL-005) - Glass Valance
(#OCK-S50A) - LP Conversion Kit
(#815-CL2) - Co-Linear Air Chute
(#900-085) - 4" Restrictor Plate
or
or
PAGE 7