Complete Fan Wiring Installation - kozy heat 911XL Installation And Operation Manual

COMPLETE FAN WIRING INSTALLATION

#911XL
#911XL-RAD OPTIONAL FAN KIT #911-028
#911XL-RAD with optional fan kit #911-028
1. If not previously done, turn gas valve and manual shut off valve to „OFF‟. Disconnect gas line from manual shut off valve.
2. Remove lower grill if previously installed.
3. Slide left, then right fan through the lower grill opening (right side of gas valve), positioning onto their corresponding mounting studs on
the floor of fireplace. Secure each fan with (2) nuts included.
4. Connect left fan extension wires to terminals on right fan.
5. Install electrical box with speed control assembly onto either right or left mounting studs located toward front of fireplace.
6. Connect the flexible gas line to the manual shut off valve. Turn the manual shut off valve to „ON‟.
CAUTION: CHECK CONNECTION FOR LEAKS.
7. Re-install lower grill.
#911XL & #911XL-RAD
1. Place thermostatic control switch on bottom of insert firebox.
2. Plug power cord into electrical box receptacle.
3. Turn speed control counter-clockwise until it „clicks‟. This is the „OFF‟ position.
4. Turn speed control „ON‟ by turning the knob clockwise past the „click‟ - this is the highest setting.
ELECTRICAL WARNING: DO NOT ALLOW MILLIVOLT BOARD COMPONENTS (WIRES, FLEXLINES, ETC.) TO COME IN CON-
TACT WITH FAN ASSEMBLY COMPONENTS.
NOTE: This appliance must be electrically grounded and connected in accordance with local codes, or in the absence of local codes, with
the National Electrical Code, ANSI/NFPA 70 Current Edition, or the Canadian Electrical Code CSA C22.1.
NOTE: This fan will not operate unless the speed control has been turned „ON‟ and sufficient heat has been applied to the temperature
control switch. The fan will turn „ON‟ and „OFF‟ automatically as the fireplace heats and cools. Adjust fan to desired speed while it is
running.
TEMPERATURE CONTROL SWITCH POSITION
Before adjusting the temperature control switch, unplug the 3-prong
plug on the fan cord from the receptacle. Adjust position of the
temperature control switch to a warmer location under the firebox to
turn fan „ON‟ sooner or move it to a cooler location under firebox
to turn the fan „ON‟ later. The fan will turn on when the sensor in
the temperature control switch reaches 110° F and will turn „OFF‟
when the sensor reaches 90° F. After adjustment, plug the 3-prong
plug on fan cord into the receptacle.
Temperature Control Switch (looking through lower grill opening).
PAGE 18