Prepare Existing Fireplace; Glass Frame Assembly; Remove Glass Frame Assembly; Install Glass Frame Assembly - kozy heat 911XL Installation And Operation Manual

PREPARE THE EXISTING FIREPLACE
PREPARE THE EXISTING FIREPLACE
WARNING: CUTTING ANY SHEET-METAL PARTS OF THE FIREPLACE, IN WHICH THE GAS FIREPLACE IS TO BE
INSTALLED, IS PROHIBITED.
1. The refractory, glass doors, screen rails, screen mesh and log grates may be removed from existing fireplace before installing this gas
fireplace insert.
2. Any smoke shelves, shields and baffles may be removed if attached by mechanical fasteners.
3. If necessary, remove firebrick on sides and back of the existing fireplace to obtain at least the minimum opening requirements listed on
page 8.
4. The fireplace flue damper can be fully blocked open or removed for installation of this gas fireplace insert.
5. Remove existing chimney cap.
6. Clean chimney and inside of fireplace to prevent creosote smell from entering the home.
7. Place „THIS UNIT HAS BEEN MODIFIED‟ label in the bottom of existing firebox so it will be visible if this gas fireplace insert is re-
moved.
8. Run electrical wiring if hard wiring to the pre-installed electrical box in the insert if desired.
See „FAN DIRECT WIRE INSTALLATION‟ instructions on page 10.
9. Run any electrical wiring needed if insert is to be run by a thermostat.
10. Run gas line to existing fireplace.

REMOVE GLASS FRAME ASSEMBLY

A. Locate the spring-loaded handles securing glass frame assembly at the bottom of firebox.
B. Pull bottom handles out and „down‟ to release glass frame assembly bottom.
C. Pull bottom of glass frame assembly out and lift up off tabs at top of firebox.

INSTALL GLASS FRAME ASSEMBLY

A. Place glass frame assembly top over tabs at top of firebox.
B. Pull bottom handles out and „up‟ to secure glass frame assembly bottom.

GLASS FRAME ASSEMBLY

WARNING: DO NOT REMOVE GLASS ASSEMBLY
PAGE 9
WARNING: DO NOT OPERATE THIS FIRE-
PLACE WITH THE GLASS REMOVED,
CRACKED OR BROKEN. REPLACEMENT
OF GLASS ASSEMBLY, #700-07T SHOULD
BE DONE BY A LICENSED OR QUALIFIED
SERVICE PERSON.
WHEN HOT!