Table of Contents
Advertisement
6.2.4: Entering a Password
If Password Protection has been enabled in the software for Reset and/or Configuration (see Chapter 5 in the
Communicator EXT User's Manual
try to reset the meter and/or configure settings through the front panel.
• PASS appears in the A window and 4 dashes appear in the B window. The leftmost dash is flashing.
1. Press the Down button to scroll numbers from 0 to 9 for the flashing dash. When the correct number
appears for that dash, use the the Right button to move to the next dash.
Example: The left screen, below, shows four dashes. The right screen shows the display after the first
two digits of the password have been entered.
2. When all 4 digits of the password have been selected, press the Enter button.
• If you are in Reset Mode and the correct Password has been entered, "rSt dMd donE" or "rSt EnEr
donE"appears and the screen resumes auto-scrolling parameters.
• If you are in Configuration Mode and the correct Password has been entered, the display returns to the
screen that required a password.
• If an incorrect Password has been entered, "PASS ---- FAIL" appears
and:
• The previous screen is redisplayed, if you are in Reset Mode.
• The previous Operating Mode screen is redisplayed, if you are in
Configuration Mode.
e
Electro Industries/Gauge Tech
for information), a screen appears requesting a Password when you
Doc# E149701
6-4
Advertisement
Table of Contents
