Print Jobs; Loading Pre-Drilled Stock Into The Ohcf (1 Or 2 Trays) For 2-Sided Print Jobs - Xerox D95 User Manual

a) Make the desired selections for Paper Type/Paper Weight, Paper Size, and Paper
Color.
b) If necessary, make the desired changes to paper curl and alignment adjustment.
Note
Refer to the System Administration Guide for detailed information on the paper
curl and alignment adjustment options.
c) Select Save until you are returned to the tray settings window.
10. Select Confirm to close the window.
Loading pre-drilled stock into the OHCF (1 or 2 Trays) for 2-sided

print jobs

1. Select the appropriate paper stock for your print job.
2. Pull out the tray slowly until it stops.
3. Open the ream of paper with the seam side facing up.
4. Fan the sheets before loading them into the tray.
5. Load and register the paper against the right side of the tray as depicted below for
LEF direction:
6. Load and register the paper against the right side of the tray as depicted below for
SEF direction:
7. Adjust the paper guides by pressing in the guide release and carefully moving the
Edge Guide until it lightly touches the edge of the material in the tray.
Do not load materials above the MAX line located on the rear Edge Guide.
8. If necessary, set the skew adjustment levers to the desired position for your print job.
9. Gently push in the tray until it comes to a stop.
If enabled by your System Administrator, the Paper Tray settings screen may be
displayed on the UI.
10. If changes have been made to the paper tray, select the Change Settings button;
otherwise, proceed to the next step.
Xerox ® D95/D110/D125/D136 Copier/Printer
User Guide
Oversized High Capacity Feeder (OHCF), 1 or 2 trays (Trays 6/7)
18-7