Xerox D95 User Manual page 189

Symptoms Check
Copies are not Is the document scanning
made at the glass or the document cover
desired size. dirty?
Is the document made of
highly transparent material
like a transparency?
Is the document at the
correct position?
Is the document loaded
correctly?
Are the document guides at
the correct position?
Is the document folded or
bent?
Is the document a non-
standard size?
Paper is often Is paper loaded properly in
jammed or the paper tray?
wrinkled.
Is the paper tray set
properly?
Is the paper damp?
Is the paper curled?
Are the paper and paper tray
settings correct?
Are there any torn pieces of
paper still remaining inside
the machine or is there a
foreign object in the
machine?
Is out-of-spec paper loaded
in the tray?
Is the paper tray loaded past
its maximum fill line?
Is the paper guide set
correctly?
Xerox ® D95/D110/D125/D136 Copier/Printer
User Guide
Remedy
Clean the document feeder glass or the
document cover.
Place the document on the document glass,
and place a white sheet of paper on top of the
document before making a copy.
Load the document correctly.
Properly set the document guides.
Straighten and properly reset the document.
Enter the document size.
Load paper correctly.
To ensure tray closure, Firmly push it in as far
as possible.
Replace with paper from a new ream.
Either turn the paper so that the curl is facing
down in the paper tray, or replace with paper
from a new ream.
Make sure the paper and paper tray selected
match the paper size settings.
Refer to "Paper Tray Settings" in the System
Administration Guide.
Open the door of the machine or slide out the
paper tray to remove the torn paper or the
foreign object.
Replace with paper that meets machine
specifications.
Load paper in the paper tray so that it does not
exceed the maximum fill line.
Load the paper correctly, and apply the paper
guides lightly.
Problem solving
15-31