Xerox D95 User Manual page 183

Fault code Cause and Remedy
027-745 Cause: The address of the DNS server is not registered on the machine.
Remedy: Either register the address of the DNS server on the machine or set the
address of the job template server by an IP address.
027-746 Cause: The specified job template pool server protocol settings are incorrect.
Remedy: Set up the correct port.
027-750 Cause: Attempted to command a print job to a scanned document.
Remedy: Scanned document cannot be printed. Configure the job flow correctly.
027-751 Cause: When following the job flow, an error occurred.
Remedy: Check the settings for the job flow.
027-752 Cause: In a job flow, a job start was specified before a required item was input.
Remedy: Configure a default to input the required item in the job flow or change
the job flow to have the required item link to the mailbox.
027-753 Cause: The necessary port for the job flow is either not enabled or is unavailable.
Remedy: Have your System Administrator check the port status.
027-770 Cause: PDL (Printer Description Language) error detected by the controller while
processing a network print job.
Remedy: Cancel and resend the print job. If problem continues, reboot both the
controller and the printer and resend job. If the problem persists, call the Customer
Support Centre for further help/instructions.
027-771 Cause: Disk full error message on the controller.
Remedy: Cancel job. Delete unwanted files from the controller. Resend the network
print job.
027-796 Cause: When the machine is configured to only print attached documents when
received by mail, a message with no attachments is discarded upon receipt.
Remedy: To print the mail body or header information as well, change settings in
the CentreWare Internet Services Properties screen.
Refer to "E-mail Print" in the System Administration Guide.
027-797 Cause: Invalid received mail output destination.
Remedy: Specify a correct output destination and send the mail again.
062-277 Cause: A communications error occurred between the document scan unit and
the document feeder.
Remedy: Contact the Customer Support Center.
062-790 Cause: The scanned document is copy-protected.
Remedy: Refer to the Safety Guide, and check to see if the document can be
copied.
065-210 Cause: An error occurred with the machine.
Remedy: Contact the Customer Support Center.
071-210 Cause: Paper Tray 1 malfunctioned.
Remedy: Contact the Customer Support Center. Trays other than Paper Tray 1
can be used.
072-210 Cause: Paper Tray 2 malfunctioned.
Remedy: Contact the Customer Support Center. Trays other than Paper Tray 2
can be used.
Xerox ® D95/D110/D125/D136 Copier/Printer
User Guide
Problem solving
15-25