Specifications - Xerox D95 User Manual

049-972
Cause: Stacker limit or full sensor fault
Remedy: Perform the following:
Power Off/On the machine
If the problem still exists, contact the Customer Support Center.
Open the HCS front door.
Remove any paper from the stacker cart.
Close the HCS front door.
049-973
Cause: HCS falsely detects that the Paper Unload button is pressed.
Remedy: Perform the following:
Power Off/On the machine
If the problem still exists, contact the Customer Support Center.
Open the HCS front door.
Remove any paper from the stacker cart.
Close the HCS front door.

Specifications

Paper guidelines
Stacker Tray will accept 55-350 gsm (either coated or uncoated stock) with the
possibility of degraded stock quality and increased jam rate for stocks that are heavier
than 300 gsm.
Transparencies may be run to either the Top Tray or the Stack Tray. Stack height
should be limited to 100 transparencies.
Coated paper lighter than 100 gsm may not run as reliably as coated paper heavier
than 100 gsm.
Non-standard papers longer than 305 mm (12 in.) in the feed direction require 210
mm (8.3 in.) minimum measurement across the feed direction.
Non-standard papers shorter than 254 mm (10 in.) in the cross-feed direction require
330 mm (13 in.) minimum measurement in the feed direction.
Xerox ® D95/D110/D125/D136 Copier/Printer
User Guide
High Capacity Stacker (HCS)
20-25