Power On/Off; Power Saver Mode - Xerox D95 User Manual

Perfect Binder (D110/D125/D136 with integrated controller)
6 Adhesive unit
Adhesive is applied to the spine of the book block.
7 Binding area
The adhesive-coated book block and cover media are bound together and then continue
to the next phase of the binding process. If no cover media was specified, the book
block continues through the paper path for trimming and delivery to the book stacker
tray.
8 Trimming
The bound book edges are trimmed to size by the cutter unit.
9 Trimmer waste tray
Once the book edges are trimmed, the paper cuttings are deposited in the trimmer
waste tray.
10 Book stacker tray
Finally, the finished books are stacked in the book stacker tray.

Power on/off

Important
The binder's power is controlled by the system. When the system powers on, the binder
also powers on. When the system powers off, the binder does the same.

Power Saver mode

The binder's power saver mode is independent from that of the system's power saver.
However, if desired, it is possible to set both power saver modes to the same interval.
The binder's default time is 10 minutes; after 10 minutes of inactivity, the binder enters
power saver (and the heater unit for the adhesive switches off). This time may be changed
to reflect a value of 10-120 minutes; you must enter the Administrator mode to change
it.
If the system's power saver is set to a time interval that is less than the binder's, then
when the system enters power saver, the binder also enters power saver. By default the
system automatically enters power saver after 15 minutes of inactivity.This time may
be changed to reflect a value of 10-120 minutes; you must enter the Administrator mode
to change it.
Note
To keep the binder at maximum running efficiency, it is recommended that the power
saver time interval for the binder is kept at the default 10 minutes.
21-12 User Guide