Fault Codes - Xerox D95 User Manual

SquareFold Trimmer Module

Fault codes

If a jam/fault occurs in the SquareFold Trimmer Module, the machine's UI displays a
jam/fault message. The following table provides a list of fault codes for the SquareFold
Trimmer Module and a list of related finisher fault codes.
Note
The top covers cannot be opened during normal operation or when the machine is idle.
The covers can be opened only when an indicator is lit and a jam/fault occurs within the
SquareFold Trimmer Module. For indicator details, refer to the control panel information
earlier in this section.
012-115
Cause: Finisher jam or fault
Remedy: Perform the following:
1. If machine UI continues to reflect a fault/jam, go to the finisher:
Open the finisher.
Remove any jams
Close the finisher cover(s).
2. Follow the instructions shown on the machine UI to resume printing.
3. If fault persists, power off/on the machine.
4. If fault persists, call for service.
012-264
Cause: Finisher jam or fault
Remedy: Perform the following:
1. If machine UI continues to reflect a fault/jam, go to the finisher:
Open the finisher.
Remove any jams
Close the finisher cover(s).
2. Follow the instructions shown on the machine UI to resume printing.
3. If fault persists, power off/on the machine.
4. If fault persists, call for service.
012-302
Cause: Finisher jam or fault
Remedy: Perform the following:
1. If machine UI continues to reflect a fault/jam, go to the finisher:
Open the finisher.
23-16 User Guide