Date & Time - Quantum DXi4510 User Manual

Chapter 9: DXi4000 Configuration
System
Date & Time
190
logical port. The frame reception is completely dependent on
the transmission algorithm of the Ethernet switch. The bonding
mechanism does not balance the frame reception.
• LACP (Mode 4) - This option (Link Aggregation Control
Protocol) is based on the 802.3ad IEEE standard for aggregating
Ethernet ports. If the bonding algorithm is set to LACP, the
Ethernet switch ports must be configured in a 802.3ad based
Link Aggregation group (LAG) in LACP mode. The frame
reception and transmission is controlled by the LACP between
the bonded ports and the Ethernet switch ports.
6 Click Apply.
Note: After you apply a Segmented network configuration, the
Custom option is no longer available. To change to a Custom
configuration, you must select the Basic configuration and
apply it. After the DXi reboots, you can proceed with
configuring the Custom network option.
The Date & Time page allows you to set the system date and time of the
DXi4000. You can specify a Network Time Protocol (NTP) server to
synchronize the system time with, or you can manually enter the date
and time.
Note: If you intend to join the DXi4000 to a Windows network using
Active Directory for NAS storage, Quantum recommends using
an NTP Server to set the system date and time (see
Domain on page 144).
To access the Date & Time page, on the System page, click the Date &
Time tab (see
Figure 102).
Windows
Quantum DXi4000 User's Guide