Deleting Tape Drive Firmware Used In Autoleveling - Quantum Scalar i40 User Manual

Chapter 7: Updating Firmware
Updating and Autoleveling Tape Drive Firmware
Deleting Tape Drive
Firmware Used in
Autoleveling
168
If you installed a tape drive firmware image to override the library's
baseline image used for autoleveling, you can delete it. You cannot
delete the library's baseline tape drive firmware images. For more
information, see About Tape Drive Firmware Autoleveling
Note: Deleting tape drive firmware for autoleveling only deletes the
firmware and makes the library's baseline tape drive firmware
available for autoleveling. It does not initiate autoleveling or
install firmware on the tape drives. To initiate autoleveling, see
Initiating Tape Drive Firmware Autoleveling
You can only delete tape drive firmware on the Web client.
Web Client
1 Select Tools > Drive Operations.
The Tools - Drive Operations screen appears.
2 Select Upload/remove tape drive firmware for autoleveling and
click Next.
The Tape Drive Firmware Autolevel screen appears. The screen lists
the vendor, type, interface type, form factor, and firmware revision
number for all tape drives that the library supports, whether or not
they are installed in the library.
3 Select the tape drive firmware you want to delete.
4 Click Delete.
The Progress Window appears. The Progress Window contains
information on the action, elapsed time, and status of the
requested operation. Do one of the following:
• If Success appears in the Progress Window, the tape drive
firmware was successfully deleted. The library's default baseline
tape drive firmware will now be used for autoleveling.
• If Failure appears in the Progress Window, the tape drive
firmware update was not successfully deleted. Follow the
instructions listed in the Progress Window to resolve any issues
that occurred during the operation.
5 To initiate autoleveling, see
Autoleveling on page 169.
Initiating Tape Drive Firmware
Quantum Scalar i40 and Scalar i80 User's Guide
on page 164.
on page 169.