Setting Term Pwr; Figure 2-2 Jumper Installed On Pin Pair 3 / 4 Enables Termination Power (Term Pwr) - Quantum DLT 8000 Product Manual

Configuring, Installing, and Operating the Tape System

2.2.2 Setting TERM PWR

A SCSI bus must be terminated at each end of the bus. At least one device on the bus
must supply terminator power (TERM PWR).
To configure the DLT 8000 tape drive to supply TERM PWR, install a jumper block on
pin pair 3 / 4 (Figure 2-2).
Front Bezel
Figure 2–2 Jumper Installed on Pin Pair 3 / 4 Enables Termination Power (TERM PWR)
2-6
Side View of Tape System
Quantum DLT 8000 Tape System
Jumper on Pin Pair 3 / 4 enables
termination power (TERM PWR).