Standby Functionality; Figure 4.22 Magazine Release Tool In Use - Quantum FastStor 1 User Manual

Figure 4.22 shows the
release tool inserted into
the correct hole on the
right hand side magazine
bezel.

Standby Functionality

On the front panel a standby button is available.
To activate Standby mode, press the button for a minimum of 2 seconds. The
FastStor 1 will enter a standby mode in a controlled manner. The following takes
place before the FastStor 1 goes into standby mode:
1. Finish any FastStor 1 activity.
2. Controlled aborting of tape drive activity; buffered data is flushed to tape;
cartridge is unloaded from drive but not ejected.
3. The display is turned off.
4. No FastStor 1 activity is allowed until the standby button is pressed again.
5. While in standby mode, the attached server/host can see the two SCSI
devices in the FastStor 1, but the SCSI status will be "not ready."
6. The green LED on the front will blink with short blinks- long intervals.
7. To leave the standby mode, press the standby button for 2 second. The
FastStor 1 will then restart and perform a full inventory.
40

Figure 4.22 Magazine release tool in use

FastStor 1 Installation and User Guide