Configuring Library Security Settings - Quantum Scalar i500 User Manual

Configuring Library Security Settings

Scalar i500 User's Guide
The paths to open the appropriate screens are as follows:
• From the web client, select
.
Conditioning
• From the operator panel, select
.
Conditioning
Administrative users can use the operator panel
to change the following security features:
•
Network Interface
library. This setting is enabled by default to allow external access.
• — enables or disables Secure Shell (SSH) services, such
SSH Services
as SSH (port 22), from accessing the library. This setting is enabled by
default.
• — enables or disables external attempts to discover the library
ICMP
by pinging it (by means of the Internet Control Message Protocol
[ICMP] Echo packets). This setting is enabled by default.
• — enables or disables remote access to the library via the
Remote UI
web client (port 80). This setting is enabled by default.
• — enables or disables SNMP traffic to the library (port 161).
SNMP
This setting is enabled by default.
• — enables or disables SMI-S traffic to the library (port 5988).
SMI-S
This setting is enabled by default.
This setting differs from enabling/disabling SMI-S in the
Note:
Tools > System Settings
Settings
You cannot configure the security settings from the web client. The path
to open the appropriate screen is as follows:
• From the operator panel, select
Chapter 3 Configuring Your Library
Configuring Library Security Settings
Setup > I/O Blades > Data Path
Setup > I/O Blades > Data Path
— enables or disables all external access to the
menu (see
on page 118).
Tools > Security
screen
Security Settings
Configuring System
.
117