Communications Modes; Connecting The Phone Line; Local Terminal Information Settings - Xerox WorkCentre 7300 Series Administrator's Manual

Communications modes:

• G3 (Auto) - Normal Fax communications. The machine automatically switches modes in the following
order of priority: Unique SG3 - Unique ECM - Unique G3 - ITU-T SG3 - ITU-T ECM - ITU-TG3
depending on the capabilities of the remote terminal.
• F4800 - Select this mode when transmitting over noisy or bad telephone lines, as can be the case with
overseas calls.

Connecting the phone line:

LINE 1 Connect the fax to a public switched telephone network (PSTN). An external telephone cannot be
connected.
TEL An external telephone is connected here.
LINE 2 (Line 2) Connect to a public line.
LINE 4 (Line 4) Connect to a public line.

Local Terminal Information Settings

1. Press the Log In / Out button to enter System Administration Mode.
2. On the keypad enter [11111] or current password. Touch Enter when finished.
3. Press the Machine Status button on the Control Panel.
4. Touch the Tools tab.
5. Touch Fax Mode Settings.
6. Touch Local Terminal Information.
7. Select the items to enter information and touch Change Settings.
a. Enter in a Local Name, up to 20 characters, then touch Save.
b. Enter a Company Logo, up to 30 characters, then touch Save.
c. Enter a Machine Password, up to 20 digits, then touch Save. Note: The password prevents your
machine from receiving faxes, or being polled by other machines that are not F-Code compatible.
d. Enter G3 Fax ID, up to 20 digits, then touch Save.
e. Enter G3 Dial Type, Tone, 10pps, or 20pps, then touch Save.
f. Enter G3 Line Type, PSTN or PBX, then touch Save.
8. When complete, touch Close repeatedly until the Tools tab screen is displayed.
9. Wait several seconds for the Auto Clear service to log you out.
79