Ipv4 Ip Filter (Ip Address Restriction); Exiting The Protocol Settings Menu And Returning To The Device's Tools Tab Screen; Tcp/Ip Lpd Enablement; To Access Lpd Settings At The Device - Xerox WorkCentre 7300 Series Administrator's Manual

IPv4 IP Filter (IP Address Restriction)

1. Use your workstation's web browser to access the Internet Services (web pages) residing on the
Device to set the IP Address or Addresses to use with this feature BEFORE enabling the feature,
either here or with Internet Services. This will prevent unintentionally locking yourself out from
communicating with the Device from your own IP address. For full instructions, refer to the IP
Filtering (IP Address Restriction) topic in the Internet Services section of this guide.
2. In the Protocol Settings menu, press the selection line labeled IPv4 IP Filter.
3. Press the Change Settings button.
4. On the settings screen, note which of the two buttons is highlighted as the current setting for IP
Address restriction. The available settings are Enabled or Disabled. Disabled is the factory default
setting.
5. To change settings, press your setting of choice, then press the Save button.
6. To return to the Protocol Settings menu, without making changes, press the Cancel button.

Exiting the Protocol Settings Menu and returning to the Device's Tools tab screen

1. To exit the Protocol Settings menu, returning to the Tools tab screen, press the rectangular Close
button in the upper right corner of the Protocol Settings menu screen.
2. Wait several seconds and the Auto Clear service should log you out.
Note: If you changed any settings in the Protocol Settings menu, the Device will automatically reboot to
register and enable your new settings.

TCP/IP LPD Enablement

To support TCP/IP printing through the workstation's LPR port in the case of Windows XP, the LPD (Line
Printer Daemon) MUST be enabled at the device.
To view or change the Device's LPD setting, perform the following steps:

To access LPD Settings at the Device

1. Press the rectangular Log In / Out button on the Control Panel.
2. Press the "1" key on the numeric keypad five consecutive times. (This is the factory default
"password.")
3. Press Enter on the touch screen.
4. Press the Machine Status button on the Control Panel.
5. Press the Tools tab.
6. Press Connectivity & Network Setup.
7. Press Port Settings.
8. When the Port Settings menu displays, press the selection line labeled LPD.
9. Press the Change Settings button in the lower right corner of the Port Settings menu screen.
10. When the LPD selections menu displays, note that you have a choice of setting selections by
numbered horizontal lines, with the current status of each setting shown. The Close button in the
upper right corner of the screen returns you to the Port Settings menu. After pressing the selection, to
access available settings press the Change Settings button in the lower right corner of the touch
screen.
20