To Enable Ip Sec; Scheduled Image Overwrite - Xerox WorkCentre 7300 Series Administrator's Manual

To enable IP Sec:

1. Open your Web browser and enter the TCP/IP address of the machine in the Address or Location field.
Press Enter.
2. Click the Properties tab.
3. Click the symbol to the left of the Security folder.
4. Select IP Sec in the directory tree.
5. Enable the Protocol by placing a checkmark in the Enabled box.
6. Select Pre-Shared Key to use the Shared Secret (between this device and remote computers also
possessing the secret). Note that if you select Digital Signature, the Shared Secret boxes will be
grayed out and you will have to supply a Certificate stored on this device to the remote computer that
wishes to send IP Sec encrypted data to this device. Refer to the Configuring certificates with
CentreWare Internet Services topic in this Encryption section for full information.
7. Enter the Shared Secret (a password) in the Shared Secret and Verify Shared Secret boxes.
8. Select Enabled (default setting) for the Communicate with Non-IP Sec Device setting, so that
computers not set up for encryption can still communicate with this device.
9. Use the on line Help for assistance with other available settings.
10. Click Apply when done and supply the Administrator User Name and Password, if prompted. The
default is 11111 and x-admin.

Scheduled Image Overwrite

A TCP/IP network-connected device can be set to overwrite image data on a scheduled basis.
Note: The Image Overwrite will delete all image data from the hard disk!
To enable a scheduled image overwrite, perform the following steps:
1. At your workstation:
a. Open your Web browser.
b. Enter the IP address of the machine in the Address or Location field.
c. Press Enter.
2. Click the [Properties] tab.
3. If prompted, type or enter your System Administrator user name and password.
• user name (default): 11111
• password ( default): x-admin
4. Click the [Security] folder.
5. Click the [Scheduled Image Overwrite] link.
Note: The Image Overwrite will delete all image data from the hard disk!
6. In the Scheduled Image Overwrite area, in the Advanced Settings box, on the Schedule Image
Overwrite line, click [Enabled].
7. Configure the Frequency, Day, Week, Hour, and Minute settings.
Note: The machine will be taken off line each day at the time specified to perform the overwrite.
8. Click [Apply]. Restart the device at the prompt.
137