Port Status (Ethertalk Enablement); Exiting The Ethertalk Selection Menu; Exiting The Port Settings Menu And Returning To The Tools Tab Screen; Configuring Ethertalk Settings With Internet Services - Xerox WorkCentre 7300 Series Administrator's Manual

Port Status (EtherTalk Enablement)

1. On the EtherTalk selection menu, press the selection line labeled Port Status.
2. Press the Change Settings button.
3. On the Port Status screen, note which of the two buttons is highlighted as the current setting for
EtherTalk Enablement. The available settings are Enabled or Disabled. To print with EtherTalk, this
setting must be Enabled.
4. To change settings, press your setting of choice, then press the Save button.
5. To exit the screen, without making any changes, press the Cancel button.

Exiting the EtherTalk Selection Menu

To exit the EtherTalk selection menu, which returns you to the Port Settings menu, press the rectangular
Close button in the upper right corner of the touch screen.

Exiting the Port Settings Menu and returning to the Tools tab screen

1. To exit the Port Settings menu, returning to the Tools tab screen, press the rectangular Close button in
the upper right corner of the Port Settings menu screen.
2. Wait several seconds for the Auto Clear service to log you out.
Note: If you changed any settings in the Port Settings menu, the Device will automatically reboot to
register and enable your new settings.

Configuring EtherTalk Settings with Internet Services

1. Open your Web browser and enter the TCP/IP address of the Device in the Address or Location field.
Press Enter.
2. Click the Properties Tab.
3. Click the plus (+) symbol to the left of Connectivity, then the Protocols file folder.
4. Select AppleTalk (EtherTalk) in the directory tree.
Note: If this selection is unavailable, click on the Port Status hot link, check the EtherTalk box, then
click Apply.
5. The available selections include:
Printer Name.
Zone Name.
6. Enter the name that you wish to assign to this Printer. This is the name that will appear in the
Chooser.
7. Either accept the default zone of * which lets the closest router assign the Device to a zone, or assign
the Device to a zone (with a 32 character naming limit).
8. Click the Apply button to accept changes, or the Undo button to return settings to their previous
values. Note: Setting changes are not applied until you restart (reboot) the Device.
30