Ethertalk (Appletalk) Configuration; To Access Ethertalk Settings At The Device - Xerox WorkCentre 7300 Series Administrator's Manual

5. The available selections include:
Port Number, with a default value of 631. This is the port number assigned by IANA (Internet Assigned
Numbers Authority.
Additional Port Number Entry box.
A TBCP Filter checkbox (displayed when PostScript is enabled) Click Help for an explanation of the
use of this feature..
Administrator Mode Checkbox. This is disabled by default. Consult the On-Line Help for use of this
feature.
DNS Enablement Checkbox.
Connection Timeout Entry Box.
6. Verify that the DNS Enablement Checkbox is checked (enabled) by default. If enabled, the DNS
Server will resolve Host Names to IP Addresses, in support of printing with IPP.
7. Enter a Time Out value for jobs being sent to the Device through this Port. This is the length of time
that the Controller will wait for an end of job command before printing the current job.
8. Click the Apply button to accept changes, or the Undo button to return settings to their previous
values. Note: Setting changes are not applied until you restart the Device.

EtherTalk (AppleTalk) Configuration

The EtherTalk Protocol enables workstation to Device communications over the EtherTalk (AppleTalk)
network.

To access EtherTalk Settings at the Device

1. Press the Log In / Out button on the Control Panel.
2. Press the "1" key on the numeric keypad five consecutive times. (This is the factory default
"password.")
3. Press Enter on the touch screen.
4. Press the Machine Status button on the Control Panel.
5. Press the Tools tab.
6. Press Connectivity & Network Setup.
7. Press Port Settings.
8. Press the EtherTalk selection line on the Port Settings menu.
9. Press the Change Settings button in the lower right corner of the Port Settings menu screen.
10. When the EtherTalk selection menu displays, note that you have only one selection available on a
single, numbered horizontal line, with the current status of this setting shown. The Close button in the
upper right corner of the screen returns you to the Port Settings menu. After pressing the horizontal
line selection, to access available settings press the Change Settings button in the lower right corner of
the touch screen.
29