Installation Procedure; Enabling Ports And Setting Tcp/Ip - Xerox WorkCentre 7300 Series Administrator's Manual

Installation Procedure

This section describes the configuration procedure to use the Scan to PC (FTP/SMB) feature on the
machine.
The following two steps are necessary to use the Scan to PC (FTP/SMB) feature.
• Enabling the required ports and Setting TCP/IP
Enable the FTP port and SMB port on the Device, and then set the machine's IP address. If you will
be using SMB on a Microsoft Network, make sure to enable either DNS or WINS as part of the TCP/IP
configuration. For FTP, make sure that DNS is enabled.
• Preparing an FTP directory or SMB shared folder on the receiving computer (server or workstation).
Create an FTP directory or SMB shared folder to receive scanned documents over the network.

Enabling Ports and Setting TCP/IP

To use Scan to PC (FTP/SMB) you need to enable the applicable Ports (SMB or FTP client) on the Device,
and make sure that an IP address has been set on the machine.
Note: The configuration can also be performed using CentreWare Internet Services.
For information on how to use CentreWare Internet Services, refer to the Internet Services section of
this guide.
1. Display the System Administrator Menu screen.
a. Press the Log In/Out button.
b. Enter the user ID with the numeric keypad or the keyboard displayed on screen, and select Enter.
Note: The default user ID is "11111". When using the Authentication feature, a password is required.
The default password is "x-admin".
c. Press the Machine Status button on the Control Panel.
d. Touch the Tools tab.
2. When using the SMB protocol, enable the SMB port.
a. Select Connectivity & Network Setup.
b. Select Port Settings.
c. Select SMB and then select Change Settings.
d. Select Port Status and then select Change Settings.
e. Select Enabled then select Save.
f. Select Close until the Port Settings screen is displayed.
3. When using the FTP protocol, enable the FTP client port.
a. From the Tools tab screen, select Connectivity & Network Setup, then Port Settings.
b. From the Port Settings screen, select FTP Client and then select Change Settings.
c. Select Port Status and then select Change Settings.
d. Select Enabled then select Save.
e. Select Close repeatedly until the Tools tab screen is displayed.
4. Set an IP address.
If an IP address is already set, this step is not necessary. Also, in an environment with DHCP or
BOOTP, configure the way to obtain an IP address. If the address cannot be obtained automatically, or
static configuration is preferred, configure an IP address, a subnet mask, and a gateway address as
follows.
90