Quick Split; Split Lock - Icom IC-7200 Instruction Manual

Quick Split

This item turns the quick split function ON or OFF.
When this item is set to ON, push and hold
1 sec. to set the undisplayed VFO frequency and oper-
ating mode are set the same as the displayed VFO fre-
quency and operating mode.
See pgs. 58, 59 for details.
on : The quick split function ON
oF : The quick split function OFF

Split Lock

This item turns the split lock function ON or OFF.
When this item is set to ON, the transmit frequency can
be adjusted by rotating [DIAL] while pushing and holding
* even if the lock function is activated.
RIT
* The transmit frequency check function ("XFC"; as below) must
be turned ON in advance.
See p. 59 for split frequency operation details.
NOTE: When the split lock function is ON, the transmit
frequency cannot be adjusted by rotating [DIAL] while
pushing and holding [PTT] even if the lock function is
not activated.
on : The split lock function ON
oF : The split lock function OFF
XFC
This item turns the XFC (transmit frequency check) func-
tion ON or OFF.
on : The transmit frequency can be monitored while
pushing and holding
oF : The transmit frequency check function OFF
NOTE: When the XFC function is turned ON, the RIT
calculation function (p. 44) is not available.
Auto Tune
The optional AT-180
antenna tuner
start capability which starts tuning if the SWR is higher
than 1.5:1.
on : The automatic tune starts even when the tuner is
turned OFF during HF bands operation.
oF : The tuner remains OFF even when the SWR is poor
(1.5:1)
SPLIT
RIT
has an automatic
for
SET MODE
ON (default)
OFF (default)
OFF (default)
OFF (default)
10
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
76