Memory Operation; Memory Channels; Memory Channel Selection - Icom IC-7200 Instruction Manual

7

MEMORY OPERATION

■ Memory channels

The transceiver has 201 memory channels including
2 scan edge channels.
Memory mode is very useful for quickly changing to
often-used frequencies.
MEMORY
CHANNEL
Regular memory
channels
Scan edge
memory channels

■ Memory channel selection

V/M
q Push to select memory mode.
➔
• " " appears.
w Rotate [M-CH] to select the desired memory
channel.
• If the RIT control indicator lights orange, push
M-CH/RIT
to set the [M-CH] control to memory chan-
SET
nel control. (See below for details)
• All memory channels including blank channels can be
selected.
• [UP]/[DN] on the microphone also selects the mem-
ory channels. (The only programmed memory chan-
nels are selectable.)
Channel decreases
About the [M-CH] control:
When the RIT control indicator lights orange, the
memory channels cannot be selected with rotat-
ing the [M-CH] control because the [M-CH] con-
trol acts as the RIT control. So, push
set the [M-CH] control to memory channel control
(RIT control indicator goes out).
61
MEMORY
CHANNEL
NUMBER
Independent transmit and receive frequencies
1–199
and mode in each memory channel.
One frequency and one mode in each memory
P1, P2
channel as scan edges for programmed scan.
RIT control indicator
goes out
Channel increases
M-CH/RIT
SET
All 201 memory channels are tuneable which means
the programmed frequency can be tuned temporarily
with [DIAL], etc., in memory mode.
CAPABILITY
[EXAMPLE]: Selecting memory channel 17.
VFO mode
Memory mode
to
Channel 17 is selected.
COPY OVER-
CLEAR
TO VFO WRITING
Yes Yes
Yes Yes
RIT control
indicator
ANF
NB NR
METER
V/M 1 A/B 2 3
SPLIT
1.8 = 3.5 7
4 5 6
MW M-CL AGC
10 14 18
7 8 9
COMP SCAN VOX
21 24 28
.
MODE TS
0 F-INP ENT
RIT MNF
GENE 50
BAND
TUNER FILTER
P.AMP
ATT
M-CH/RIT
SPCH
SET
[M-CH]
Push
Appears
Rotate [M-CH]
Yes
No