Tunneling Configuration Task List; Configuring Ipv6 Manual Tunnel; Configuration Prerequisites; Configuration Procedure - HP 4800G Series Configuration Manual

Tunneling Configuration Task List

Complete the following tasks to configure the tunneling feature:
Configuring IPv6
over IPv4 tunnel

Configuring IPv6 Manual Tunnel

Configuration Prerequisites

Configure IP addresses for interfaces (such as the VLAN interface and loopback interface) on the
device to ensure normal communication.
Specify one of the above interfaces as the source interface of the tunnel.
Ensure reachability between the tunnel source and destination addresses.

Configuration Procedure

Follow these steps to configure an IPv6 manual tunnel:
To do...
Enter system view
Enable IPv6
Create a tunnel interface and
enter tunnel interface view
Configure an
IPv6 address
for the tunnel
interface
Specify the IPv6 manual tunnel
mode
Task
Configuring IPv6 Manual Tunnel
Configuring 6to4 Tunnel
Configuring ISATAP Tunnel
Use the command...
system-view
ipv6
interface tunnel number
ipv6 address { ipv6-address
Configure a
prefix-length |
global unicast
ipv6-address/prefix-length }
IPv6 address
or a site-local
ipv6 address
address
ipv6-address/prefix-length
eui-64
ipv6 address auto link-local
Configure a
link-local IPv6
ipv6 address ipv6-address
address
link-local
tunnel-protocol ipv6-ipv4
—
Required
By default, the IPv6 packet
forwarding function is disabled.
Required
By default, there is no tunnel
interface on the device.
Required
Use either command.
By default, no IPv6 global
unicast address or site-local
address is configured for the
tunnel interface.
Optional
By default, a link-local address
will automatically be created
when an IPv6 global unicast
address or site-local address is
configured.
Required
By default, the tunnel is an IPv6
manual tunnel. The same
tunnel mode should be
configured at both ends of the
tunnel. Otherwise, packet
delivery will fail.
1-5
Remarks
Optional
Optional
Optional
Remarks