Wins - Savin MLP145 Operating Instructions Manual

wins

Use the "wins" command to configure WINS server settings.
❖ Viewing settings
msh> wins
• If the IPv4 address obtained from DHCP differs from the WINS IPv4 ad-
dress, the DHCP address is the valid address.
❖ Configuration
msh> wins "interface_name" {on | off}
• {on} means "active" and {off} means "inactive".
• Be sure to specify the interface.
• wlan can be specified only when the IEEE 802.11b interface unit and the
optional SDRAM module are installed.
Interface name
ether
wlan
❖ Address configuration
Use the following command to configure a WINS server IP address:
msh> wins "interface_name" {primary|secondary} "IP address"
• Use the "primary" command to configure a primary WINS server IPv4 ad-
dress.
• Use the "secondary" command to configure a secondary WINS server IPv4
address.
• Do not use "255.255.255.255" as the IPv4 address.
❖ NBT (NetBIOS over TCP/IP) Scope ID Selection
You can specify the NBT scope ID.
msh> wins "interface_name" scope "scope ID"
• The scope ID can be entered using up to 31 alphanumeric characters.
• Be sure to specify the interface.
• wlan can be specified only when the IEEE 802.11b interface unit and the
optional SDRAM module are installed.
Interface name
ether
wlan
Interface configured
Ethernet interface
IEEE 802.11b interface
Interface configured
Ethernet interface
IEEE 802.11b interface
Remote Maintenance by telnet
5
217