Savin MLP145 Operating Instructions Manual page 154

Making Printer Settings Using the Control Panel
❖ Bypass Priority
When the different paper size or type is specified from the driver, you can
specify which setting is given priority to, machine setting or command.
• Machine
• Driver/Command
Note
❒ Default: Driver/Command
❖ Auto Tray SW
Specify the printer to change printing to the suitable tray, when printer driver
specifies different paper size or type from the current tray.
• Off
• On
4
Note
❒ Default: Off
❖ RAM Disk
If the optional hard disk is not installed for PDF Direct Print, select a value of
2 MB or higher.
This menu appears only when the optional hard disk is not installed.
• 0 MB
• 2 MB
• 4 MB
• 8 MB
• 16 MB
Note
❒ Default: 4 MB
Important
❒ When the amount of SDRAM is small and RAM Disk is set to 16 MB, print-
ing may not be possible depending on the print job and duplex printing
may be canceled. If this happens, increase the amount of SDRAM, or set
RAM Disk to 8 MB or less.
Reference
For details about the optional SDRAM module, see Hardware Guide.
142