Wins - Savin MLP31n Operating Instructions Manual

6. Monitoring and Configuring the Printer
srvcert {on | off}
imca {on | off}
srvid "character string"
• You can use this command only when the IEEE 802.11b interface unit is installed.
6

wins

Use the "wins" command to configure WINS server settings.
Viewing settings
msh> wins
• If the IPv4 address obtained from DHCP differs from the WINS IPv4 address, the DHCP address
is the valid address.
Configuration
msh> wins "interface_name" {on | off}
• {on} means "active" and {off} means "inactive".
• Be sure to specify the interface.
• wlan can be specified only when the IEEE 802.11b interface unit is installed.
ether
wlan
Address configuration
Use the following command to configure a WINS server IP address:
msh> wins "interface_name" {primary|secondary} "IP address"
• Use the "primary" command to configure a primary WINS server IPv4 address.
228
Parameter
Interface name
Value configured
Usable characters: ASCII 0x20-0x7e(128
bytes). The default is blank.
You can set the server certificate. The default is
"off".
You can enable or disable the certificate when
the intermediate certificate authority is present.
The default is "off".
You can set the server ID and subdomain of the
certificate server.
Interface configured
Ethernet interface
IEEE 802.11b interface