Dns - Savin MLP145 Operating Instructions Manual

dns

Use the "dns" command to configure or display DNS (Domain Name System)
settings.
❖ View settings
The following command displays current DNS settings:
msh> dns
❖ IPv4 DNS server configuration
The following command enables or disables the IPv4 DNS server address:
msh> dns "number" server "server address"
The following command displays a configuration using the IP address
192.168.15.16 on a DNS 1 server:
msh> dns 1 server 192.168.15.16
• You can register IPv4 DNS Server address.
• You can register up to three IPv4 DNS server numbers.
• You cannot use "255.255.255.255" as the DNS server address.
❖ IPv6 DNS server configuration
The following command enables or disables the IPv6 DNS server address:
msh> dns "number" server6 "server address"
• You can register IPv6 DNS Server address.
• You can register up to three IPv6 DNS server numbers.
❖ Dynamic DNS function setting
msh> dns "interface_name" ddns {on|off}
• You can set the dynamic DNS function "active" or "inactive".
• {on} means "active" and {off} means "inactive".
• wlan can be specified only when the IEEE 802.11b interface unit and the
optional SDRAM module are installed.
Interface name
ether
wlan
Interface configured
Ethernet interface
IEEE 802.11b interface
Remote Maintenance by telnet
5
193