Spoolsw - Savin MLP145 Operating Instructions Manual

Monitoring and Configuring the Printer
❖ Interval configuration
msh> sntp interval "polling_time"
• You can specify the interval at which the printer synchronizes with the op-
erator-specified NTP server. The default is 60 minutes.
• The interval can be entered from 0, or between 16 and 10,080 minutes.
• If you set 0, the printer synchronizes with the NTP server only when you
turn the printer on. After that, the printer does not synchronize with the
NTP server.
❖ Time-zone configuration
msh> sntp timezone "+/-hour_time"
• You can specify the time difference between the printer clock and NTP
server clock. The values are between –12:00 and +13:00.

spoolsw

5
Use the "spoolsw" command to view and configure Job Spool settings.
You can only specify diprint, lpr, ipp, ftp, smband sftp protocol.
• The "spoolsw" command for configuring Job Spool settings is available only
when the optional hard disk is installed.
❖ View settings
The Job Spool setting appears.
msh> spoolsw
❖ Job Spool setting
msh> spoolsw spool {on | off}
Note
❒ Specify "on" to enable Job Spool, or "off" to disable it.
❖ Resetting Job spool setting
msh> spoolsw clear job {on | off}
• When the printer power is cut during job spooling, this determines wheth-
er to reprint the spooled job.
❖ Protocol configuration
msh> spoolsw diprint {on | off}
msh> spoolsw lpr {on | off}
msh> spoolsw ipp {on | off}
msh> spoolsw smb {on | off}
msh> spoolsw ftp {on | off}
msh> spoolsw sftp {on|off}
• You can specify the settings for diprint, lpr, ipp, smb and sftp.
210