Maintenance Menu Parameters - Savin MLP145 Operating Instructions Manual

Making Printer Settings Using the Control Panel

Maintenance menu parameters

This section explains about parameters that can be set on the Maintenance menu.
❖ Image Density
You can select the print image density.
• -3 to 3
Reference
For details, see Hardware Guide.
❖ Registration
You can adjust the starting position of the printing page.
• Prt. Test Sheet
4
You can print the registration test sheet.
Tray 1, Tray 2, Tray 3, Tray 4, LCT, Bypass Tray, Duplex.BackSide
Note
❒ Only the installed trays appear on the display panel.
• Adjustment
You can select the start position for printing on a page.
Vert.:Tray 1, Vert.:Tray 2, Vert.:Tray 3, Vert.:Tray 4, Vert.:LCT, Vert.:By-
pass, Vert.:Dup.Back, Hori.:All Trays
Note
❒ Only the installed trays appear on the display panel.
❖ Del. All Temp
This appears on the menu only when the hard disk is installed.
Use this function to delete all temporarily saved documents (Sample Print,
Locked Print and Hold Print data) at once.
❖ Del. All Stored
This appears on the menu only when the hard disk is installed.
Use this function to delete all saved documents (Stored Print data) at once.
❖ HD Format
Appears when the hard disk is installed.
❖ Date/Time
Use this to set the date and time.
❖ WL.LAN Signal
You can check the signal strength when using LAN.
The menu appears when the 802.11b interface unit and the optional SDRAM
module are installed.
❖ WL.LAN Defaults
Reset the wireless LAN to default.
The menu appears when the 802.11b interface unit and the optional SDRAM
module are installed.
134