Table of Contents
Advertisement
show
Use the "show" command to display network interface board configuration settings.
❖ View settings
msh> show
• If "-p" is added, you can view settings one by one.
Reference
For details about the information displayed, see p.228 "Configuring the Net-
work Interface Board".
slp
Use "slp" command to view and configure SLP settings.
msh> slp ttl "ttl_val"
• You can search the NetWare server using SLP in the PureIP environment of
NetWare 5/5.1 and Netware 6/6.5. Using the "slp" command, you can con-
figure the value of TTL which can be used by SLP multicast packet.
• The default value of TTL is 1. A search is executed only within a local seg-
ment. If the router does not support multicast, the settings are not available
even if the TTL value is increased.
• The acceptable TTL value is between 1 and 255.
smb
Use the "smb" command to configure or delete the computer or workgroup
name for SMB.
❖ Computer Name settings
msh> smb comp "computer name"
• Set computer name using up to 15 characters. Names beginning with
"RNP" or "rnp" cannot be entered.
❖ Working Group Name settings
msh> smb group "work group name"
• Set workgroup name using up to 15 characters
❖ Comment settings
msh> smb comment "comment"
• Set comment using up to 31 characters
Remote Maintenance by telnet
5
205
Advertisement
Table of Contents
