Savin MLP145 Operating Instructions Manual page 234

Monitoring and Configuring the Printer
Messages
Malfunction: Z-folding unit
Malfunction:Lower Paper Tray(s)
Memory Low: Data Storage
Miscellaneous Error
Mismatch: Paper Size
Mismatch: Paper Size and Type
Mismatch: Paper Type
Near Replacing: Black PCU
Near Replacing: Develop. Unit K
5
Near Replacing: Fusing Unit
Nearly Full: Waste Toner
Need more Staples
No Paper: Interposer Tray
No Paper: LCT
No Paper: Selected Tray
No Paper: Tray 1
No Paper: Tray 2
No Paper: Tray 3
No Paper: Tray 4
Not Detected: B2 Lever
Not Detected: Black Toner
Not Detected: Develop. Unit (K)
Not Detected: Duplex Feed Unit
Not Detected: Duplex Unit
Not Detected: Finisher
Not Detected: Fusing Unit
Not Detected: Input Tray
Not Detected: LCT
Not Detected: PCU (K)
Not Detected: Tray 1
222
Description
There is a problem with the Z fold unit.
There is a problem with the Lower Paper
Tray(s).
Memory shortage has occurred while the doc-
ument was being accumulated.
Other error has occurred.
Indicated paper tray does not contain paper of
selected size.
Indicated paper tray does not contain paper of
selected size and type.
Indicated paper tray does not contain paper of
selected type.
Prepare the new black photoconductor unit.
Prepare the new development unit (black).
Prepare the new fusing unit.
Waste toner bottle is nearly full.
Stapler has almost run out of staples.
There is no paper in interposer unit.
There is no paper in Large Capacity tray.
There is no paper in specified tray.
There is no paper in tray 1.
There is no paper in tray 2.
There is no paper in tray 3.
There is no paper in tray 4.
B2 lever is not correctly set.
Black toner is not correctly set.
The development unit (black) is not correctly
set.
The duplex feed unit is not correctly set.
The duplex unit is not correctly set.
Finisher is not correctly set.
The fusing unit is not correctly set.
The paper feed tray is not correctly set.
A large amount of paper feed tray is not cor-
rectly set.
The photoconductor unit (black) is not correct-
ly set.
Tray 1 is not correctly set.