Hostname; Ifconfig - Savin MLP145 Operating Instructions Manual

Monitoring and Configuring the Printer

hostname

Use the "hostname" command to change the printer name.
❖ View settings
msh> hostname
❖ IPv4 Configuration
msh> hostname "interface_name " "printer_name"
• Enter the printer name using up to 63 alphanumeric characters.
• You cannot use a printer name starting with "RNP" or "rnp".
• The Ethernet interface and IEEE 802.11b interface will have the same print-
er name.
• wlan can be specified only when the IEEE 802.11b interface unit and the
optional SDRAM module are installed.
5
Interface name
ether
wlan
❖ Initializing the printer name for each interface
msh>hostname "interface_name" clear "name"

ifconfig

Use the "ifconfig" command to view and configure TCP/IP (IP address, subnet
mask, broadcast address, default gateway address) for the printer.
❖ View settings
msh> ifconfig
❖ IPv4 Configuration
msh> ifconfig "interface_name" "parameter" "address"
• If you did not enter an interface name, it is automatically set to the Ethernet
interface.
• wlan can be specified only when the IEEE 802.11b interface unit and the
optional SDRAM module are installed.
Interface name
ether
wlan
The following explains how to configure an IPv4 address 192.168.15.16 on
Ethernet interface.
msh> ifconfig ether 192.168.15.16
196
Interface configured
Ethernet interface
IEEE 802.11b interface
Interface configured
Ethernet Interface
IEEE 802.11b Interface