Savin MLP145 Operating Instructions Manual page 262

Using a Printer Server
I
From the [Print Server Information] menu, select [Print Server Configuration].
J
From the [Print Server Configuration] menu, select [Printer Configuration].
K
Select the printer indicated as [Not Installed].
L
To change the printer name, enter a new name.
A name "Printer x" is assigned to the printer. The "x" stands for the number
of the selected printer.
M
As type, select [Remote Parallel, LPT1].
The IRQ, Buffer size, Starting form, and Queue service mode are automatical-
ly configured.
N
Press the {Esc} key, and then click [Yes] on the confirmation message.
O
Press the {Esc} key to return to [Print Server Configuration Menu].
P
Assign print queues to the created printer.
Q
From [Print Server Configuration Menu], select [Queues Serviced By Printer].
R
6
Select the printer created.
S
Press the {Insert} key to select a queue serviced by the printer.
You can select several queues.
T
Follow the instructions on the screen to make other necessary settings.
Following these steps, check that the queues are assigned.
U
Press the {Esc} key until "Exit?" appears, and then select [Yes] to exit
PCONSOLE.
V
Start the print server by entering the following from the console of the Net-
Ware server.
If the print server is in operation, quit and restart it.
❖ To quit
CAREE: unload pserver
❖ To start
CAREE: load pserver "print_server_name"
Note
❒ If the printer works as configured, the message "Waiting for job" appears.
250