Aim Symbology Id Defaults - Intermec 700 Series User Manual

SECTION 6

AIM Symbology ID Defaults

Refer to the official AIM documentation on symbology identifiers for full informa-
tion on the different processing options supported.
Bar Code ID
Symbology Character
F
Codabar
H
Code 11
A
Code 39
G
Code 93
C
Code 128
I
Interleaved 2 of
5
X
Matrix 2 of 5
MSI M
PDF 417/ L
Micro PDF 417
Modifier Characters
0 Standard Codabar symbol. No special processing.
1 ABC Codabar (American Blood commission)
concatenate/message append performed.
2 Reader has validated the check character.
4 Reader has stripped the check character before transmission.
0 Single modulo 11 check character validated and transmitted.
1 Two modulo 11 check characters validated and transmitted.
3 Check characters validated but not transmitted.
0 No check character validation nor full ASCII processing. All data
transmitted as decoded.
1 Modulo 43 check character validated and transmitted.
3 Modulo 43 check character validated but not transmitted.
4 Full ASCII character conversion performed. No check character
validation.
5 Full ASCII character conversion performed. Modulo 43 check
character validated and transmitted.
7 Full ASCII character conversion performed. Modulo 43 check
character validated but not transmitted.
0 No options specified. Always transmit 0.
0 Standard data packet. No FNC1 in first or second symbol
character position after start character.
1 EAN/UCC-128 data packet. FNC1 in first symbol character
position after start character.
2 FNC1 in second symbol character position after start character.
4 Concatenation according to International Society for Blood
Transfusion specifications was performed. Concatenated data
follows.
0 No check character validation.
1 Modulo 10 symbol check character validated and transmitted
3 Modulo 10 symbol check character validated but not transmitted.
0–F
For symbologies or symbology options not listed, a code character
with the value 0--F may be assigned by the decoder manufacturer
to identify those symbologies and options implemented in the
reader.
0 Modulo 10 symbol check character validated and transmitted.
1 Modulo 10 symbol check character validated but not transmitted.
0 Reader set to conform with protocol defined in 1994 PDF 417
specifications.
1 Reader set to follow protocol of ENV 12925 for Extended Channel
Interpretation (all data characters 92 doubled).
2 Reader set to follow protocol of ENV 12925 for Basic Channel
Interpretation (data characters 92 are not doubled).
3 Code 128 emulation: implied FNC1 in first position.
4 Code 128 emulation: implied FNC1 after initial letter or pair of
digits.
5 Code 128 emulation: no implied FNC1.
700 Series Color Mobile Computer User's Manual
Scanner Support
6-63